Keep moisture, salt and malfunctioning wiring out of your ride – bike or car.
Why you need it
Rain-soaked roads, winter puddles, road-salt, and engine-bay splatter: these are the threats that quietly lead to electrical gremlins and corrosion. Whether you’re riding a motorbike or driving a car, the wiring looms, connectors, switches and engine bays are exposed and vulnerable. Lanoguard Moto Electrics Spray is engineered to stop those threats in their tracks, displacing water and forming a long-lasting protective barrier.
Key features & benefits
-
Instant waterproofing for electrics – Seals out moisture in wiring looms, engine-bay terminals and bike connectors.
-
Non-conductive to 70,000 volts – Safe for use on all electrics and circuit boards; prevents electrolysis and short circuits.
-
Heat resistant up to 450 °C and non-evaporating – Ideal for engine bays and high-temperature motorbike parts; once applied, it stays put even under pressure-washing or extreme heat.
-
Resists fuel, oil, salt and spray – Because it’s petroleum-resistant and built for harsh conditions, it holds up where typical sprays fail.
-
Safe on rubbers and plastics – Doesn’t perish seals or hoses; it even nourishes them.
Where to apply
-
-
Motorbikes: electrical connectors, battery terminals, wiring looms, plug caps, sensor connections, and exposed metal fixings.
(Avoid spraying directly onto controls or switches such as the indicator or starter switch — these are best left free-moving.)
-
Cars: battery terminals, alternator plugs, fuse boxes, sensor connectors, and the back of fog light housings where moisture can enter.
(Use around the electrical connections and housings — not over the lens or light surface.)
-
Ideal for: riders and drivers facing damp, salt, or winter storage conditions.
How to use
-
Ensure the area is clean and dry (remove oil or heavy grime).
-
Shake well and spray evenly over the wiring, connectors or electrics.
-
Allow to set (no wipe-off required).
-
For high-temperature zones, allow full cure before riding/driving.
-
Re-apply seasonally or after heavy exposure to road salt or deep puddles.
Make it part of your protection regime
Whether you already protect your undercarriage or your chain, don’t overlook the electrics. For motorbike owners, this spray is the final piece of the full-scope kit that locks in long-lasting performance. For car owners with road-salt exposure or engine-bay work done, it offers peace of mind that electrical faults won’t sneak up on you.
Common Problems This Solves
Damp Engine Bays & Moisture in Wiring
Cold mornings, puddles and condensation can cause misfires, rough running or failed starts. Moisture creeps into wiring looms and connectors — especially in damp garages or wet weather.
Moto Electrics Spray displaces that moisture and seals electrics, keeping your engine running smoothly even in the worst UK conditions.
Corroded Battery Terminals & Earth Connections
Corrosion on battery posts or earth points causes poor starting and intermittent electrical faults.
A light coating of Moto Electrics Spray prevents oxidation, keeping clean, reliable contact and better voltage delivery.
Fog Light & Headlight Moisture Ingress
Ever noticed condensation or failed bulbs after a wet drive or ride? That’s moisture entering through the rear connectors or housings.
Spray around the electrical connections and backs of light units (not over the lens) to block damp and prevent corrosion in those tricky-to-reach plugs.
Sensor & Connector Failures
Modern bikes and cars rely on sensors and plugs that sit low to the ground and face road spray, salt and grime. Over time, they corrode and trigger warning lights or electrical gremlins.
Moto Electrics Spray forms a non-conductive, corrosion-resistant barrier that protects those vulnerable connectors season after season.
Water Damage After Washing or Riding in Rain
Pressure washing or heavy rain can leave bikes with flickering lights or reluctant ignitions when water seeps into plug caps and connectors.
A quick coat of Moto Electrics Spray stops water getting in and keeps everything working perfectly — without making controls sticky or tacky.
Winter Storage Woes
Bikes and cars stored in damp garages often suffer poor starting and corroded contacts by springtime.
Treat electrics with Moto Electrics Spray before storage to lock out moisture and ensure an easy start when you’re ready to roll again.
