- Prevents rust, verdigris and electrolysis and it provides a highly effective barrier against corrosion and barnacle build up
Applied to my marine bronze propeller and P-bracket and stainless steel prop shaft after preparing surfaces with 600 wet & dry paper. As it was a warm day in May, there was no need to pre warm the product as it went on very smoothly and easily with a cloth. I will examine the prop etc at the end of the season in October and compare the level of fouling with how I have prepared it in the past with just 600 wet & dry followed by a metal polish.
Easier than most and goes a fair way. Will know better it it has kept winter at bay
finally took the plunge and purchased this product after reading the many good reviews,
very happy with it, power washed the wheel arches and as much of underside of vehicles Isuzu d max , and Honda crv,
left to fry for a bit then sprayed on the lanoguard, it was as easy as described , the sprayer worked faultlessly, and it gave good even coverage with minimal waste, or mess, and little effort, on;y advice if possible get a pit or ramp to make the job so much easier,
i ordered the 2 ltr container, and did the d max and a good bit of the crv and still have some left. will certainly buy more and use again
Used on a land rover. Applies easily and looks great
After using Dinitrol for years and the associated task of masking up cleaning shutz gun out i though i would try Lanoguard. I have to say i am impressed, easy to apply, no mess and a little goes a long way. The accessories make the job so much easier, i must admit i haven't used the grease yet but will when time allows.
When it arrived I thought that's never going to do the whole underneath of the motorhome but it as with a little left for you for touch ups, next project buy the inner silk and channeling kit. Well pleased
Absolutely fabulous item, had undercarriage, subframe & engine compartment protected with LANOGUARD, great kit very easy to use, will thoroughly recommend
I spent a lot of money on having a professional under body treatment done on my 2007 Freelander 2 just to find the job done was not up to all the guarantees that they promised, with Lanoguard I now know I have covered all the important areas easy to use minimal effort I can really recommend this product I wish I new about this product before spending a lot of money.
I have previously used the Wax-based product and although an effective rust treatment the one finds application is tricky with blocked nozzles, having to cover rubber etc. Plus smoke and flames should you come back to do welding in later years!
Lanogaurd has none of these issues and could not have been easier to apply to my ageing but much loved X Type Jaguar. It has even stopped my "Winter-Suspension Creak." (Jag owners will know!)
So far I have only done the middle and rear end but very happy to see only a third of the bottle used so more than enough to tackle the few rust prone area at the front and probably enough to do the whole of my Ford Streeka.
So it is actually good value for money also.
Great service great product very easy to apply.
Just finished protecting the underneath of my car, very easy to use, covers very quick. I pressure washed on Wednesday and completed it today.
Very pleased with product, easy to use.
I bought the smaller bottle kit for my passat and my mums wee aygo.. plenty to do both and I ended up using a lot of the the grease on my passat to try and save it from rust 😂…. Watch you don’t get it on alloys as its cling is incredible and I struggled to remove lanoguard from the alloys with a jet wash after it got on them from my hands, it will definetly stay on the bottom of the car
,Very easy product to use, jet washed underbody first & allowed to dry off, then brushed any loose dirt off before blowing down with compressed air, probably overkill, so prep time was probably a couple of hours
i stood the 2ltr can in some warm water to make it flow better through the chassis injection tube, i was surprised how far this product goes, really covers well, the application to the chassis & underbody took around an hour & used 2ltrs of Lanoguard,
Excellent product & so easy to use
Kit looks awesome, not had time to use it yet, Will send review when tried it. Sure it Will do the job 👍
Lanoguard explained BY OUR FOUNDER, MARK BEAUMONT
COMMERCIAL CUSTOMERS WE ARE PROUD TO SUPPLY WITH LANOGUARD:
Our products are used industrially in the airport, marine, automotive, and construction sectors. Find out more about our industrial credentials here.
Prepare your vehicles for the winter ahead...
Increased salt on the roads and moisture in the air can leave your vehicles and machinery highly vulnerable to winter rust and corrosion.
Check out our Winterize page to find out more about how and why you should check your underbody and protect it from the harsh, cold months ahead.