Safe, strong, and coating-friendly – this is your essential pre-wash for dirt removal without compromise.

1. Preparation - Ensure your vehicle is dry, cool to the touch and parked out of direct sunlight.

Shake the bottle well before use.

2. Dilution - Dilute as per the instructions on the back of the bottle:

Ratio 1:10 (1 part snow foam to 9 parts water).

Adjust the dilution ratio and/or flow rate of the snow foam applicator for the desired density level.

3. Application - Apply evenly using a foam lance, pressure sprayer, or trigger bottle. Expect a rich, clinging foam designed to lift grime an loosen bonded dirt without stripping wax or coatings.

4. Dwell Time (amount of time product is left on a surface to work effectively)

Allow the foam to dwell for around 5 minutes. Don’t let it dry out – adjust timing if you’re working in warm or windy conditions.

5. Rinse Thoroughly - When rinsing start at the bottom of vehicle working upwards.

Use a pressure washer for best results. If that’s not available, a hose with good pressure will also work.

KEY TIPS

• If the foam not clinging well? - Check your dilution ratio and equipment setup. Increase product concentration slightly for thicker coverage.
• If the product dries on the surface? - Simply re-apply and rinse thoroughly. Avoid working in direct sun or on a hot surface.
• What to do if you have residue after rinsing? - May indicate under-rinsing or product drying before removal. Use more water pressure and rinse more thoroughly.

SiO₂-infused and coating-safe, this is no ordinary shampoo. It’s designed to clean, enhance, and extend your vehicle’s protection in one simple wash.

1. Preparation - Ensure your vehicle is cool to the touch and parked out of direct sunlight.

Rinse the vehicle thoroughly to remove loose dirt and debris or use a pre wash like Lanoguard Snow Foam for best results.

2. Dilution - Dilute 15ml: 5L of water in a bucket (2 capfuls to an average household bucket).

3. Application - Use a clean wash mitt or sponge to apply the shampoo to the vehicle one panel at a time. Start from the top and work your way down to avoid dragging dirt.

This product is bucket-wash recommended. It is not designed for foam cannon use.You may notice a lower than expected presentation of suds yet a smooth slick washing experience.

4. Rinse - Rinse off thoroughly with clean water, ensuring all residue is removed. A pressure washer or hose works well here.

5. Drying - Use a clean, high-quality drying towel for a streak-free finish. Avoid air drying to prevent water spots.

Consider following up with a window cleaner on your windows.

Enjoy improved water beading and a shiny finish. Protection builds over time with repeat application.

KEY TIPS

• If you have streaks or water spots after drying? - Always dry using a clean, absorbent towel. Avoid letting water evaporate naturally in sun or wind.
• If you have poor suds or cleaning power? - Ensure proper dilution. If water is very hard, increase shampoo slightly or consider using filtered water.
• Not seeing hydrophobic effect? - The SiO₂ layer builds with use but can be diminished by using aggressive detergents between washes. Stick with Lanoguard-safe products.